...... If possible I'll use some kind of wood or plastic L shaped scoop to
remove some of the old grease. Haven't looked yet to see if this is even
possible.
Mentioned wheel bearing noise check because there might be a little too
much end play at axle stub in question.

On Monday, May 9, 2016, Neil N <musomuso@gmail.com> wrote:
Grease is some kind of Mercedes type, .....
>
>
> On Monday, May 9, 2016, Dennis Haynes <d23haynes57@hotmail.com
> <javascript:_e(%7B%7D,'cvml','d23haynes57@hotmail.com');>> wrote:
>
>> You don't need to check the wheel bearings for noise. When they do
>> finally go bad it will be very obvious. ..... The most important part is
>> for the housing to not be over stuffed. Too much grease will force past any
>> seal or even force the seal out.
>>
>> Dennis
>>
>>
>> > Date: Mon, 9 May 2016 10:45:05 -
>
>
>
>

--
Neil n

Blog: Vanagons, Westfalia, general <http://tubaneil.blogspot.ca>

1988 Westy Images <https://picasaweb.google.com/musomuso/New1988Westy>

1981 Westfalia "Jaco" Images, technical <http://tubaneil.googlepages.com/>

Vanagon-Bus VAG Gas Engine Swap Group <http://tinyurl.com/khalbay>