

| Subject: | Re: Oil pressure light and buzzer |
| From: | David McNeely |
| Date: | Mon, 23 May 2016 14:04:46 -0700 |
I also have a starter switch in the engine compartment. Just a push button switch, right above the license plate. Same scenario, ignition switch on steering column must be on. Quite helpful when trouble shooting. On Mon, May 23, 2016 at 1:58 PM, John Rodgers <jrodgers113@gmail.com> wrote: > Interesting! > > I have a starter relay in the engine bay of my rig. If the engine needs > starting while I'm standing there, I just pop the cover off the relay and > press it with my finger. Starts right up. I do have to turn on the ignition > swich fo power, and turn it off by the switch. But it works! > On May 23, 2016 14:45, "Scott" <SCOTTDANIEL@turbovans.com> wrote: > > > as I shared before, > > > > in a case like this where you just want the belt off quickly.. > > > > connect your 'Remote Starter Switch-most-useful-tool-!' to your cheater > > trigger wire in the engine compartment, > > > > arrange a big flat screw driver under the belt, tap the starter, > > ..............just tap, don't crank, > > > > and the belt just flips off as easy as could be. > > > > going back together , same thing. > > > > Being able to crank the engine while you're right by it ...so, so useful > > in So Many ways ! > > > > On 05/23/2016 02:38 AM, John Rodgers wrote: > > > > BTDT! Oil light and buzzer came on regularly. Got the proper switch from > > Van Cafe and installed it - no more problem. Aggravating to change out, > > though. Had to remove the water pump pulley to get at it, and that > required > > loosening the alternator so I could remove the water pump belt. Then I > had > > to have a special socket (I made mine) to remove/replace it. A very tight > > fit! But it solved the problem! > > > > John > > On May 23, 2016 00:41, "Dennis Haynes" <d23haynes57@hotmail.com> < > d23haynes57@hotmail.com> wrote: > > > > The Waterboxer does not like 10w-30. Who rebuilt the engine? Was the case > > actually measured for wear at the bearing journals and align bored? This > is > > the usual problem with rebuilt engines not maintaining sufficient oil > > pressure. Oil pressure testing with the van sitting will not reveal the > > problem. You have to leave the gauge on and drive on the highway for a > > while. As for the switches many of the aftermarket ones are not reliable. > > Go to the dealer and pay the $$$. Also make sure the oil level is correct > > and not over filled. Over filling will cause the oil to overheat and lose > > viscosity. Adding a real oil cooling system can also be helpful. > > > > Dennis > > > > -----Original Message----- > > From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com < > vanagon@gerry.vanagon.com>] On Behalf Of > > Marc Perdue > > Sent: Sunday, May 22, 2016 10:50 PM > > To: vanagon@GERRY.VANAGON.COM > > Subject: Oil pressure light and buzzer > > > > Hi all, > > > > My '87 Westy auto is having the problem wherein the oil buzzer and light > > come on after about 15 minutes of driving when the RPMs drop below around > > 2500 RPMs. I've had the oil pressure checked and it is fine. A friend of > > mine is having the identical problem. Is the high pressure oil pressure > > switch, part number 068919081A, the culprit here? I checked the archives > > and it appeared that there may have been a problem with some of them > being > > too sensitive or something...? I'm trying to find the right part get this > > sorted out. My friend is about ready to take a hammer to his buzzer . . . > > Mine is going to be fixed by the guy who rebuilt the engine. He says he > got > > a bad batch of switches. I'm just trying to find which is the right part > > for my friend to order . . . > > > > My van has a newly rebuilt engine and is running Pennzoil 10w-30. I've > > never run less than 20w-50 in it and never had this problem, but the guy > > who built the engine swears that the pressure is fine and this weight of > > oil should be fine, that it's a faulty oil pressure switch. > > > > My friend is running 15w-50, I think, and has a fairly fresh engine as > > well. I suspect, but do not know for sure, that his oil pressure is fine. > > > > Bus Depot has this one:http://www.busdepot.com/068919081a > > Is this the right switch to fix this problem? > > > > Thanks, > > Marc Perdue > > > > > > > > >
Have something to add on this topic today? Revive this thread in the forum »