To much to write. You may call me.

631-897-0345

Sent from my Windows 10 phone

From: C. Abney<mailto:tsudonimh@GMAIL.COM>
Sent: Sunday, June 5, 2016 2:49 PM
To: vanagon@GERRY.VANAGON.COM<mailto:vanagon@GERRY.VANAGON.COM>
Subject: forward clutch assembly end-play

Bentley says to check that "play (arrow) is between 0.5-0.9mm. If NO,
select new pressure plate from table." (p. 38.18, 090 AT)

My first question is about that end play.  Is the top of the pressure
plate that distance below the wavy circlip that holds it in place when
the forward clutch assembly is installed and the circlip in place?

Next is about the friction plates I received.  There are two groups
with different thicknesses that are otherwise the same.  Am I supposed
to swap these around to get the required end-play?  That's what I've
been doing.  I mean, I don't have, and I don't think anyone has
pressure plates of varying thicknesses lying around so this is the
only way I can imagine getting that right.

I started off using the thicker ones, and couldn't get the circlip to
seat. Swapping two f-plates out lets me get the circlip seated, but
the steels and f-plates are bound and don't move... that's not the way
it should be, right?

-Charles
--
There's no .sig like the present