Skip to main content
Gerry | Vanagon
Checking account...
← vanagon.com home · Continue the discussion in the forum
Subject:Re: GOWESTY AFM no start problem
From:Dennis Jowell
Date:Fri, 1 Jul 2016 06:13:01 -0400

Altitude is 1400' to 3500'. We drive down to the Connecticut Upper valley and a over to the White Mountains. No big elevation gain here in Vermont or New Hampshire. Only time I have encountered a big difference is traveling out west 

Dennis J

Dennis Jowell
Scotch Hollow Farm
Newbury, Vermont 

> On Jul 1, 2016, at 1:19 AM, OlRivrRat <OlRivrRat@comcast.net> wrote:
> 
>        DJ
> 
>    @ What Altitude do You Live & Drive Mostly ~ It makes a Diff' in where Your Eng's Timing Needs to be ~
> 
>                                            ORR ~ DeanB
> 
>> On 30 Jun , 2016, at 10:42 AM, Dennis Jowell wrote:
>> 
>> Hall sensor is installed, Westy starts up, which is a bonus for me.
>> Now to do the timing of the WBX. I found my old timing light from Sears 1971 vintage I suspect it's NG. 
>> I'm headed down to my Sears store for a new Craftsman timing tool.
>> Any suggestions on the type I should get? Not to many choices here where we live. Sears is a 90 miles round trip.
>> It has been a long time since I timed any engine with a light. My several old VW  bugs I timed using a 12 volt bulb and a pair of alligator clips.
>> Also a little confused on the process of timing the 2.2 WBX engine.
>> Any suggestions?  or thoughts?
>> 
>> Dennis J
>> 
>> Dennis Jowell
>> Scotch Hollow Farm
>> Newbury, Vermont 
>> 
>> 
>>> On Jun 28, 2016, at 12:35 PM, Neil N <musomuso@gmail.com> wrote:
>>> 
>>> Way to go!
>>> 
>>> the pin on dizzy is not too hard to remove. Here's a pic of what I did:
>>> 
>>> http://tinyurl.com/hg2jaqp
>>> 
>>> its just a piece of annealed copper pipe. I supported other end of
>>> dizzy with piece of wood.
>>> 
>>> Are the small wires inside dizzy, to hall, at fault?
>>> 
>>> 
>>> 
>>>> On 6/28/16, Dennis Jowell <dennisjowell@gmail.com> wrote:
>>>> 
>>>> I found the problem! Worn out Hall Sensor. I added a zip tie to the plug on
>>>> the distributor not the harness. Starts right up. Thanks to the suggestion
>>>> from a Van Cafe old time mechanic and Chris their customer service person.
>>>> I have a new Hall Sensor ordered. Should have it here at the farm this
>>>> week.
>>> 
>>> -- 
>>> Neil n
>>> 
>>> Blog: Vanagons, Westfalia, general <http://tubaneil.blogspot.ca>
>>> 
>>> 1988 Westy Images <https://picasaweb.google.com/musomuso/New1988Westy>
>>> 
>>> 1981 Westfalia "Jaco" Images, technical <http://tubaneil.googlepages.com/>
>>> 
>>> Vanagon-Bus VAG Gas Engine Swap Group <http://tinyurl.com/khalbay>
>