

| Subject: | Re: Cooling fan issues |
| From: | Ryan Shawley |
| Date: | Tue, 19 Jul 2016 14:02:36 -0400 |
John if your van in question passes the resistor check per Ken's page check your grounds at the star found cluster f*** Sent from my iPhone > On Jul 19, 2016, at 1:19 PM, John Rodgers <jrodgers113@GMAIL.COM> wrote: > > Thanks Ken. On ol' Red, my '88 GL, when I turn the ignition switch to "ON" > but not to the start mode, and then turn on tne AC , the high speed fan > immediately kicks in. If I go ahead and drive it, the high speed fan runs a > while then cycles. Seems to do what is is supposed to do. > > However, on the Carat, that little test does not work. The HS fan does not > turn on, period. Yet when driving, with AC off, and in stop and go traffic, > the low speed fan does cycle. Engine hasn't ever gotten hot enough to > operate the mid speed fan. > > For both the engine cooling and AC on ol' Red, the fan seems to be running > properly. > > John > > On Jul 19, 2016 10:16, "kenneth wilford (Van-Again)" <kenwilfy@comcast.net> > wrote: > >> John, did you read this yet? >> http://www.vanagain.com/troubleshoot-your-radiator-fan/ >> >> When you turn in your AC your low speed fan should come on. I am thinking >> the fan low speed isn't working (bad resistor) and the mid speed is what >> you think is the low speed. Do the tests i my write up and let us know >> what you find. >> >> Ken >> >> On Tue, Jul 19, 2016 at 10:34 AM, John Rodgers <jrodgers113@gmail.com> >> wrote: >> >>> Finally got my Carat out of the shop, but there are problems. Low speed >>> fan >>> comes on as it should but the other two speeds don't work. Also, when the >>> AC is turned on, with the ignition on, but not in the start position. The >>> high speed fan should come on. But it does not. >>> >>> The fan switch has been replaced with new, but no joy for fan operation. >>> >>> Suggestions? >>> >>> Thanks, >>> >>> John >>> >> >> >> >> -- >> Thanks, >> Ken Wilford >> John 3:16 >> www.vanagain.com >>
Have something to add on this topic today? Revive this thread in the forum »