When I use a click wrench, I almost always set it about 20% below the
needed settings...one, to take things snug in an orderly manner, and two,
to make certain the wrench is behaving properly... especially on critical
high torque assemblies...

On Dec 1, 2016 11:33 AM, "Neil N" <musomuso@gmail.com> wrote:

Thanks Denny.

No! I never re-use TTY bolts.   ;)

A more experienced person would've stopped reefing on the bolt in
question before I did. It happened at the end of a long wrenching
day..... I could NOT believe that my new never before used torque
wrench could behave in such a manner.

The sprocket (timing belt pulley) appeared fine as did key way in
crank snout. There were no related issues prior.

Neil.

On 12/1/16, den jolliffe <sondancer77@yahoo.com> wrote:
> I had a similar issue on a 1.8 gas engine years ago, and a TD...the bolt
on
> both altho torqued correctly would sheer after a while...
> In both cases it was the timing belt pulley that had worn on the crank end
> allowing movement that sheered the bolt...the gas one was a simple
> replacement that never failed again...the TD needed a slight mod to the
end
> of the crank to fit the TDI pulley, it never failed again either...
> Just my $.02...and NEVER re-use TTY bolts, EVER...they are single use
> stretch bolts...new ones are good insurance against future failures that
> could cost you an engine...
> Denny in TO

--
Neil n

Blog: Vanagons, Westfalia, general <http://tubaneil.blogspot.ca>

1988 Westy Images <https://picasaweb.google.com/musomuso/New1988Westy>

1981 Westfalia "Jaco" Images, technical <http://tubaneil.googlepages.com/>

Vanagon-Bus VAG Gas Engine Swap Group <http://tinyurl.com/khalbay>