---------- Forwarded message ----------
From: "Don Hanson" <dhanson928@gmail.com>
Date: Dec 30, 2016 5:47 PM
Subject: Re: instilling pop top hinges
To: "Alistair Bell" <albell@shaw.ca>
Cc: "vanagon@GERRY.VANAGON.COM" <vanagon@gerry.vanagon.com>

silicone the whole bolt, just spread some silicone out about 1/8" deep, on
a scrap, then roll the length of the thresds through the silicone.  Push
the bolt through the hole and cinch it up... Standard fiberglass
boatbuilding proceedure.  Let the extra dry around the hole and bolt heads
and the nut, then peel it off the gelcoat or paint...or clean up with a wet
cloth as you install, but that's normally a pain and necessary only on a
porous surface.

On Dec 30, 2016 5:28 PM, "Alistair Bell" <albell@shaw.ca> wrote:

> I prefer mastic sealer. Sometimes called dum-dum. You get a roll of it for
> about 10 bucks at a rv supply store.
>
> It's easier to use than silicone, and I think seals better over time.
>
> Alistair
>
> > On Dec 30, 2016, at 4:03 PM, Edward V Barger <edvbarger@MAC.COM> wrote:
> >
> > Putting the 87 back together
> >
> > Thinking I should put silicone sealer on the inside of the heads of the
> carnage bolts that secure the hinges to the pop top to prevent water
> seeping in
> > Is this standard practice is there a better way ?
> >
> > ed
> >
> >
> > Edward V Barger
> > edvbarger@mac.com
> > 310 922 6251
>