Took a look at both and not seeing them as they are. But, it looks like
maybe the screw types could work if the hole is large enough to fit the
stud in the engine compartment.
Seems these would be available. I found these through an image search,
about as close as I can find.

http://www.panduit.com/en/products-and-services/products/cable-and-wire-bundling/plastic-cable-ties/plastic-cable-ties-one-piece/specialty-ties/stud-mount/PLST4HS25-TL300

I will try to get a picture and measurements, see if that helps.

thanks for the info!
Ryan

On Wed, Jan 4, 2017 at 11:22 PM <mfmagnani@sbcglobal.net> wrote:

> Have you tried McMaster.com ?
> Mike M
>
> Sent from my iPhone
>
> > On Jan 4, 2017, at 7:18 PM, Ryan Perry <rjdperry@GMAIL.COM> wrote:
> >
> > Hey everybody, Happy New year!
> > If you remember a while back I had posted about my engine biting the
> dust.
> > We are now mid install of a spanky new GoWesty 2.2 engine. With the old
> > engine out I am cleaning the bay and noticed the zip ties that hold the
> > main harness around the edge of the bay have broken. They are unique
> with a
> > hole that allows a manufactured stud on the body to slip in and slide
> over,
> > then you just regular zip tie the wires. Need 2 of these, any idea where
> > they can be sourced?  Suggestions otherwise? I'm a bit of a purist so
> would
> > like to try and find these if they still make them.  Hopefully I
> described
> > well enough but can grab pictures too when I get back to the shop.
> > Thanks
> > Ryan
> > Asheville, NC
>