If you  don't have the clips, drilling the tabs and using small cable ties
does a pretty fine job.

Jim

On Mon, Jan 23, 2017 at 11:43 AM Alistair Bell <albell@shaw.ca> wrote:

> It's strange but the last two heater boxes I have done were sealed/welded
> but also had the clips.
>
>
>
> I just took it as a little tip o' the hat from vw.
>
>
>
> -
>
> Alistair
>
>
>
> > On Jan 23, 2017, at 9:16 AM, vw_van_fan_Mark <madvws@COX.NET> wrote:
>
> >
>
> > The heater comes new without any clips. It is held together by glue or
>
> > plastic welds. Once you split the upper and lower sections you need
>
> > something to hold them together again. That is what the clips are for.
>
> >
>
> > There are other ways to hold the sections together again but the clips
>
> > are the VW way.
>
> >
>
> > If your heater already has clips you can use them again.
>
> >
>
> > Mark
>
> >
>
> > Dan N wrote:
>
> >> hi all,
>
> >>
>
> >> I am about to replace the Front heater motor... on VC site they suggest
> to
>
> >> get the heater box clips. I didn't get to there yet.. so my question...
>
> >>
>
> >> are those clips (metal) break easily and need to be replaced? Could I
>
> >> re-use the clips or they a one time use items?
>
> >>
>
> >> thanks for you help
>
> >>
>
> >> dan
>
> >>
>
>