Hi Alistair.

Thanks. Good to know. I'll be viewing the new hose soon and may be
able to check hose specs online then.

I *think* this new hose has a thinner wall construction than the
marine hose you write of. But. The Gates Vulco flex hoses I'm
replacing may not have a thick wall and have held up for about 8 years
and 50-70K miles.

If this hose is sufficient, it would eliminate a bunch of extra unions
and transitions.

re: engine swaps. If I only knew then what (little) I know now!

Neil.

On 5/11/17, Alistair Bell <albell@shaw.ca> wrote:

> Years ago I replaced one steel coolant line with marine hose, rubber.
> Greenline I think. This was in my old 82 diesel that I converted to 1800
> gasser. It worked fine for the 10 years I ran that van. This was full length
> from engine to rad. But one caveat, it was only the one line that was
> replaced, I ran the new line rubber line parallel to remaining steel. It was
> a tight fit through the body members. I don't think I could have ran two
> rubber lines.
>
> Alistair
>
>
>> On May 11, 2017, at 8:01 AM, Neil N <musomuso@GMAIL.COM> wrote:

>> I intend to replace 2 coolant flex hoses on my Vanagon with 1.25" hose
>> from my local semi truck repair shop. It's on order. It's application
>> may be for a semi truck heater core circuit.

--
Neil n

Blog: Vanagons, Westfalia, general <http://tubaneil.blogspot.ca>

1988 Westy Images <https://picasaweb.google.com/musomuso/New1988Westy>

1981 Westfalia "Jaco" Images, technical <http://tubaneil.googlepages.com/>

Vanagon-Bus VAG Gas Engine Swap Group <http://tinyurl.com/khalbay>