

| Subject: | Re: Poptop frame/catch refurb |
| From: | Patrick Seurynck |
| Date: | Wed, 5 Jul 2017 21:02:03 +0000 |
Thank you, Sir! I will get it taken apart and contact the list with what I find. Patrick On Jul 5, 2017, at 2:54 PM, Alistair Bell <albell@shaw.ca> wrote: No haven't made a kit.... add that to the list of opportunities squandered. But if you can, and have the energy and time, get a good look at the hinge and see if it needs work. There are a few on the list, Neil M for one, who have repaired the hinge in a simpler aand just as functional way. Alistair On Jul 5, 2017, at 1:50 PM, Patrick Seurynck <climb12@gmail.com> wrote: Alistair, On a minutely different subject, I ran across a writeup you had done, a while back, about rebuilding the hinged portion of the westy roof support mechanism and possibly creating a kit that could be purchased for that job. I have not taken mine apart to see what it needs but it is acting up. Have you created the rebuild kit? Patrick On Wed, Jul 5, 2017 at 2:38 PM Alistair Bell <albell@shaw.ca> wrote: > I've polished the galvey fittings, won't do that again. Apart from the > hazard of polishing zinc ( bad vapour/particles to breathe) it dulls again > pretty quickly. Mind you it did look sharp for a while. > > If I was to do it again I'd have them sandblasted and powdered. It's > expensive, well it is if you get a good company to do it, but it looks > cleaner. > > Aliatair > > > > On Jul 5, 2017, at 1:33 PM, Cunegonde <cunegonde.van.westfalia@GMAIL.COM> > wrote: > > > > Cunegonde has been in the Northwest her entire life since she was > imported. Needless to say there was the usual mildew farm in the lid > flocking, and corrosion on the pop top frame and lock. I also stripped, > cleaned and re-installed all the upholstery. Who knew it wasn't stripes > over camouflage pattern?! > > > > Now that the soft bits are cleaned, It's time to re-finish all of the > galvanized steel up there. I prefer to clean the galvanizing, and then use > a two-part epoxy paint that can handle lubricating the various joints & > bearing surfaces. Or should I go for powder coating - seems expensive for > interior pieces. > > > > What sayeth the list wisdom? > -- Sent from Gmail Mobile -- Sent from Gmail Mobile
Have something to add on this topic today? Revive this thread in the forum »