I usually break the plastic welds with a pair of vise grips (grab and rock
back and forth until they snap off), then go around with a large flat head
screw driver and pry around until all of the welds break.  Use metal clips
to put things back together.

Ken

On Wed, Sep 6, 2017 at 3:16 PM, Robert Ueltzen <robueltzen@gmail.com> wrote:

> Any suggestions on how to separate the two halves of the housing.  Mine is
> glued.  Did you use an exacto knife or a dremel tool with cutting disk? Or
> does the glue release with enough leverage (which I am afraid to try)?
>

--
Thanks,
Ken Wilford
John 3:16
www.vanagain.com