Ive done it many times with a hammer and putty knife. Start in a corner and
go around.

Jim

On Wed, Sep 6, 2017 at 2:29 PM kenneth wilford (Van-Again) <
kenwilfy@comcast.net> wrote:

> I usually break the plastic welds with a pair of vise grips (grab and rock
> back and forth until they snap off), then go around with a large flat head
> screw driver and pry around until all of the welds break.  Use metal clips
> to put things back together.
>
> Ken
>
> On Wed, Sep 6, 2017 at 3:16 PM, Robert Ueltzen <robueltzen@gmail.com>
> wrote:
>
> > Any suggestions on how to separate the two halves of the housing.  Mine
> is
> > glued.  Did you use an exacto knife or a dremel tool with cutting disk?
> Or
> > does the glue release with enough leverage (which I am afraid to try)?
> >
>
>
>
> --
> Thanks,
> Ken Wilford
> John 3:16
> www.vanagain.com
>