Ahhhh, ok. That makes more sense. The input shaft metal is fairly hard.

During install attempt, I turned the crank to help line up input shaft
and clutch disk splines. The flywheel DID rub off some tranny case
material. I can confirm with a magnet I'd guess.

The bearing was pre greased of course but I added a tiny bit more
sticky grease prior to engine install attempt.

So just for laughs, I came up with an idea for turning the input shaft
while using my Dremel to grind the chamfer at end of input shaft. (no
helper here to turn a tire while van in gear).

For list amusement: (images of thing I rigged up)

https://photos.app.goo.gl/pztKwIPTrfwun8Jc2

https://photos.app.goo.gl/0OHSpTCmuurpnacS2

https://photos.app.goo.gl/Cv82THcYxKlLakNp2

Once I got the hang of it, this actually worked well. You use your
legs to operate it. I made a mark so I knew if I was turning the shaft
360º .  String I used was a waxy type so doubled up, wrapped 3 times
around input shaft, it gripped it quite well.

Neil.

On 10/4/17, Dennis Haynes <d23haynes57@hotmail.com> wrote:

> Where did those metal shavings come from? Looks more like aluminum form the
> flywheel teeth hitting the bell housing. The bearings also looks like it is
> a bit devoid of grease. If you can clean the shavings out you are likely
> good to go.
>
> Dennis
>
>

-- 
Neil n

Blog: Vanagons, Westfalia, general <http://tubaneil.blogspot.ca>

1988 Westy Images <https://picasaweb.google.com/musomuso/New1988Westy>

1981 Westfalia "Jaco" Images, technical <http://tubaneil.googlepages.com/>

Vanagon-Bus VAG Gas Engine Swap Group <http://tinyurl.com/khalbay>