Skip to main content
Gerry | Vanagon
Checking account...
← vanagon.com home · Continue the discussion in the forum
VanagonEuroVan
Subject:=?utf-8?Q?Re:_ABA_engine_swap:_install_fuel_rail_end_for_end=3F_=28f?= =?utf-8?Q?lip_180=C2=BA=29?=
From:Chris S
Date:Mon, 16 Oct 2017 09:57:12 -0400

I was pulling my gearbox on Sunday for a rebuilt so I had a chance to inspect the exhaust.  One of the toilet bowl clips is missing as is one exhaust manifold stud. I replaced studs and used brass nuts previously. I would recommend using flex pipe sections even with the toilet bowl to keep things from buzzing off. 

Chris

Dnia 14.10.2017 o godz. 18:59 Chris S <szpejankowski@gmail.com> napisał(a):

> I can certainly attest to toilet bowl's robustness. 
> 
> Chris
> 
> Dnia 14.10.2017 o godz. 13:47 Neil N <musomuso@gmail.com> napisał(a):
> 
>> Thanks for the exhaust info. At this point, I will keep things simple by using the RV 1.8 exhaust manifold that came with the engine/diesel parts I bought. A person on the samba (Bill) swore by his "toilet bowl" exhaust set up and said the exhaust never had any cracks. Having built at least 3 different versions of exhaust for my 15º swap, I'll gladly sacrifice a few HP for exhaust longevity. .......  I hope!
>> 
>>> On Sat, Oct 14, 2017 at 7:30 AM, Chris S <szpejankowski@gmail.com> wrote:
>>> 
>>> I have the dual flex joint and was going to use it. I decided on Maik's collector because it helps with clearance in my Syncro and it is sturdier.   It's a compromise.
>>> 
>>> I won't dyno the setup but will take before and after timed runs (30-50) and report the difference.
>>> 
>>> Chris
>>> 
>>> Dnia 13.10.2017 o godz. 22:58 Don Hanson <dhanson928@gmail.com> napisał(a):
>>> 
>>> > I have the dual down pipe jetta flex then dual head-pipes extending (dyno runs done by TT show 32" is best for mid-range torque) to a merge and Magnaflow.Makes very good power...oh, and a mild Auto tech cam.
>>> >
>>> >> On Oct 13, 2017 4:25 PM, "Chris S" <szpejankowski@gmail.com> wrote:
>>  
>>> >> Speaking of scope creep. Look into AEG exhaust manifold. With minor clearancing it mounts to a 1.8 head. I had a collector made by Maik Jankord.  Using 2.5 inch pipe with two flex joints. I will install it this fall. It beats the standard toilet bowl collector I currently have.
>>> >>
>>> >> Pic of collector: https://www.thesamba.com/vw/gallery/pix/836852.jpg
>>> 
>>  
>> 
>> 
>> 
>> -- 
>> Neil n
>> 
>> Blog: Vanagons, Westfalia, general
>> 
>> 1988 Westy Images
>> 
>> 1981 Westfalia "Jaco" Images, technical
>> 
>> Vanagon-Bus VAG Gas Engine Swap Group

Have something to add on this topic today? Revive this thread in the forum »