Are these the NiLights? Manufacture website link:

https://tinyurl.com/y9bwcc52

Assuming the 18 Watts spec is correct at 12 - 13 Volts, that's 1.5 -
1.4 Amp draw for each light? So 3 Amps + stock back up light bulbs is?
I see a dedicated 10 Amp fuse and 1.0 wires in the 1990 Bentley back
up light diagram. If it was me.....

If keeping the stock back up bulbs, I'd calculate entire Amp load then
figure if the OE wire size and length could safely carry that load. If
yes, I'd tie into the reverse light switch positive wire. If the
potential load was too high, maybe replacing the OE reverse light
bulbs with LED's would cure that?

Neil.

On 7/30/18, ddbjorkman@verizon.net <ddbjorkman@verizon.net> wrote:

> Next issue.  I am installing the NiLight 18 W LED's as back up lights on the
> Westy.  Will I overload anything if I wire the two together and pull my
> power from the left reverse light connector/plug?
> Thanks;
> Dave B.
>

--
Neil n

Blog: Vanagons, Westfalia, general <http://tubaneil.blogspot.ca>

1988 Westy Images <https://picasaweb.google.com/musomuso/New1988Westy>

1981 Westfalia "Jaco" Images, technical <http://tubaneil.googlepages.com/>

Vanagon-Bus VAG Gas Engine Swap Group <http://tinyurl.com/khalbay>