I don't like the noise the slider makes.  Very distinct, in the desert
during winter, I can often hear a nearby Vanagon slamming the slider...
Often, when closing up from inside, it takes a few trys to give the slider
enough momentum to fully close at the rear..On a still night, quite loud.
  I found a plain black drawer handle that I mounted on the window sill
near the rear of the slider... Now I can roll the slider almost closed,
then pull it shut with that handle... quietly!   No more do I need to push
it back then try to get enough inerta going with the awkward front handle,
alone.

On Tue, Nov 27, 2018, 2:37 PM thewestyman <zolo@foxinternet.net> wrote:

> Before you adjust that pin on the pillar, make sure you mark a little dot
> on
> two direction, so you know where it was before you adjusted it.
> Now, if you look at the locking action, you will see, it works from top
> toward the bottom, hooking onto the pin.
> The last time I changed the rollers, I had to adjust the pin about 1/8 in.
> upward.
> The marks you make, will stay on for the next time reference.
> Of cournse, not only up or down to adjust but maybe you want it more in or
> out to be flush with the rear panel.
>
> Zoltan
>
> -----Original Message-----
> From: Dan N
> Sent: Tuesday, November 27, 2018 10:18 AM
> To: vanagon@GERRY.VANAGON.COM
> Subject: Sliding door... please help...
>
> hi all,
>
> on my van the sliding locking mechanism works well on the front (or on the
> handle end)... but on other end (the hinge end) it doesn't lock completely
> unless I close the door with my right hand and pushing the hinge part with
> my left hand to assist it then it closes well...
>
> so what part to adjust or replace?* (note: all the rollers are new and well
> lubed)*
>
> thanks in advance for any help
>
> dan
>