Dan,

So are you saying you can adjust the closure by loosening and moving and then tightening the round post on pillar?

(About 29 years ago when I bought my van, they did a total repaint.  They took the slider door off for painting purposes.  I have had cracking of the weld at post since then, about 15 years ago...the bracket that holds the post.  Got it re-welded.  But it's never been perfect; I think the adjustment was never proper following the paint work.  Would like to address that now; because this knowledge base on the List is kind of vaporizing.)

If so, that would help me very much.  My slider is all well lubricated and operates very good; but I think it's about 1/8" too low.  Shows marks on the aluminum trim piece at floor.  Also, it looks "kinda funny" when closed and observing...just looks a little low.

Rich

San Diego
 

    On Tuesday, November 27, 2018, 4:39:01 PM PST, Dan N <dn92610@GMAIL.COM> wrote:  
 
 thanks guys for the help...

per Eric help I went out and adjust the round post on the pillar... the
door is closing great now, very smooth with little effort.. but the rear of
the door is sagging a bit, off about 1/2" down, so I have redo it till it
look good and closing right... now I know what to do...

dan