Hi David,

        I had this happen when I put in a new front signal lamp.  To my surprise my bulb did fit more than one way.  But I think I actually moved two wires on the bulb connector switched the location.  This was on the advice from this list.  And that worked.  The bulb blinks at the normal speed ever since.
 

Eric Caron 
85 GL Auto 

> On Dec 16, 2018, at 6:05 PM, ddbjorkman@verizon.net <ddbjorkman@VERIZON.NET> wrote:
> 
> Thanks guys.  Dug, I believe the bulb can only be inserted one way.  The tabs on the side of the bulb ore at different heights.  But I'll still check that.
> Dave B.
> 
> -----Original Message-----
> From: Stephen Grisanti <bike2vcu@yahoo.com>
> To: ddbjorkman@verizon.net <ddbjorkman@VERIZON.NET>
> Cc: vanagon <vanagon@GERRY.VANAGON.COM>
> Sent: Sun, Dec 16, 2018 6:00 pm
> Subject: Re: Bulbs
> 
> Mine does the same. I've been advised to get matching bulbs all around.
> 
> Stephen
> 
> Mobile
> 
>> On Dec 16, 2018, at 5:36 PM, ddbjorkman@verizon.net <ddbjorkman@VERIZON.NET> wrote:
>> 
>> Hi All;Recently my passenger side marker/parking/turn signal light stopped lighting up on the parking light setting.  Turn signal fine.  I replaced the 1034 bulb with an 1157, which I thought was compatible and even long lasting.  To my surprise, it worked, but with a difference.  It blinked rapidly, as if a turn signal light was out, although the front  was blinking, as was the rear.  Drivers side blinks at rhe correct rate.  Am I looking at an anomaly between the 1034 vs.1157, or a bad ground?  Or something else?
>> Dave B.