I believe I can get a repair panel for this from Europe for you.  Or you
could weld the groove with a welder, then grind it back down to smooth
again to fill the groove.  The door is pretty heavy and the metal of the
lower track is thick steel.  Putting lighter sheet metal on top isn't going
to hold up or work very well.

Ken

On Tue, Feb 12, 2019 at 10:35 AM Markus Benne <mbenne@m-bass.com> wrote:

> I have a deep groove in my sliding door track at the bottom.
>
> Is it feasible to lay/glue a piece of stainless steel sheet metal trimmed
> to size in there for the bearing to roll on?
>
> Thanks for any tips.

--
Thanks,
Ken Wilford
John 3:16
www.vanagain.com