Yes that is correct.

Ken

On Thu, May 2, 2019 at 11:50 AM Nick DeAngelis <nicdeangelis@hotmail.com>
wrote:

> Ken I am leaning towards your kit because of the simplicity of the install
> and the ability to add oil temp later. I just watched your video on bending
> the pin over in the cluster to disable the buzzer. If I understand
> correctly doing this will still allow the idiot light in the dash to
> function the way the pre 86 system did, will come on due to low pressure at
> idle. Am I understanding that correctly?
>
> Best Regards,
>
> Nick DeAngelis
>
> > On May 2, 2019, at 8:07 AM, kenneth wilford (Van-Again) <
> kenwilfy@comcast.net> wrote:
> >
> > The kits should all be equally good.  You are getting a slightly easier
> > install with our kit I think.  We use a sandwich adapter which goes
> between
> > your oil filter and where it mounts.  You unscrew your oil filter, screw
> > this sandwich unit in there and put the oil filter back.  Plug everything
> > in with a premade harness and you are good to go.  Mount the pressure
> gauge
> > on the dash wherever you want and it is done.  Plus it is cheaper if you
> > care about that.  The stock kit uses a LED gauge but I can get something
> > that has a needle if you want to go old school.  Also the sandwich
> adapter
> > has additional ports if you want to do oil temperature, etc.
> >
> >
> https://www.vanagain.com/shop/oil-pressure-gauge-kit-for-all-waterboxer-vanagon
> >
> >
> > Ken
> >
> >> On Thu, May 2, 2019 at 9:57 AM Dan Lamb <vanagongramps@gmail.com>
> wrote:
> >>
> >> I installed the VC oil pressure gauge kit and like knowing what my
> actual
> >> oil pressure is. Would recommend. Have no experience with the VanAgain
> kit.
> >> Maybe the same?
> >>
> >> Sent from my iPhone
> >>
> >>> On May 2, 2019, at 2:07 AM, vw_van_fan_Mark <madvws@cox.net> wrote:
> >>>
> >>> The stock oil warning setup is a simple system why not fix it?
> >>> At least make sure to have a working warning light to get your
> attention
> >>> if pressure is ever essentially nil. You can bypass the buzzer easily
> >>> enough if you need to and still have a working oil light.
> >>>
> >>> Mark
> >>>
> >>>
> >>> Nick DeAngelis wrote:
> >>>> So the buzzer of death has come to visit. Not an actual oil pressure
> >> issue but rather the buzzer circuit went bad and just buzzes non stop
> which
> >> they are known to do.
> >>>>
> >>>> Anyone have any experience and/or preference between the Van-Again oil
> >> pressure gauge kit vs. the Van Cafe oil pressure gauge kit?
> >>>>
> >>>> Thanks,
> >>>> Nick
> >>>>
> >>>>
> >>>> Best Regards,
> >>>>
> >>>> Nick DeAngelis
> >>>> (815) 302-9912
> >>>> nicdeangelis@hotmail.com
> >>>> www.nicdeangelis.com
> >>>>
> >>
> >
> >
> > --
> > Thanks,
> > Ken Wilford
> > John 3:16
> > www.vanagain.com
>

--
Thanks,
Ken Wilford
John 3:16
www.vanagain.com