

| Subject: | Re: LED Panel Switches for Dometic Exhaust Fan |
| From: | Alistair Bell |
| Date: | Wed, 11 Sep 2019 18:37:35 -0700 |
Hey david, No, you must have misread my posts. On my previous van I did install the water port fan mod and thought it’s did improve the fridge working. I didn’t record any data for that set up, but I can tell you that the air coming out of the vent was warm air. Alistair > On Sep 11, 2019, at 11:16 AM, David McNeely <davmcneely40@gmail.com> wrote: > > I believe that Alistair Abell has data that show that putting a fan in the > city water port does not improve performance of the Dometic. He frequents > this list, so maybe he will speak up. Since there is a fan to remove hot > air into the van interior from behind the refrigerator through a vent > behind the box, perhaps when the additional fan is running, it just pulls > air from the van interior through the normal vent and on out, without > increasing the air flow from behind the refrigerator. Or worse, it might > interfere with the air flow that would normally take place, leaving the hot > air in place and not cooling the refrigerator or even preventing its > cooling. > > I did this for a refrigerator that was not performing, and could not tell > any difference, but then my refrigerator (now junked) had other problems, > like inadequate flame on propane due to a corroded internal propane line. > So, YMMV. > > mcneely > >> On Wed, Sep 11, 2019 at 7:40 AM Ryan Perry <rjdperry@gmail.com> wrote: >> >> Hey everyone! >> I've got my stock dometic fridge out after less than ideal performance this >> summer. I have decided to install an exhaust fan in place of my NEVER used >> city water hookup. (I live in the south so the van sees fairly high temps >> during the day) >> >> I see that the 80mm fans look to fit. Was going to run a new wire from fuse >> block and connect toggle over to the LED panel on the front. Want it to >> look as stock as possible so was going to use the little micro toggle >> switches. Problem is can't seem to find any switches that small or even >> closely match the stock. Anybody know where to source these? >> >> Anybody have good resources for any of these mods? Or more particular >> modifying the GoWesty city water hookup as an exhaust fan? >> >> Was also thinking about an internal fan for the fridge up top. Use the same >> line and locate in the same place on the LED panel. Might be a good idea >> while I have it out. >> >> Thanks as always! >> Ryan Perry >>
Have something to add on this topic today? Revive this thread in the forum »