Perhaps I did not word my question correctly.  For example, cladding on sliding
door is hanging on by the top edge.  How do I get it off?  Knock it up with a
rubber mallet?

John

On Wed, 2019-11-20 at 14:33 -0800, John Goubeaux wrote:
> I believe it is a 10mm nut on the bolts that hold the cladding to the
> clips.
>
> I used a small socket with an extender to remove/replace my cladding.
> You will then be faced with removing the plastic vertical clips/holders
> that are riveted to the body.
>
> -john
>
> On 11/20/19 12:38 PM, John H. Lauterbach wrote:
> > My '91 GL only has part of the orignal GL panels still attached, and some of
> > these are loose.  How do I remove them.  I doubt that I will replace them after
> > I send van to body shop for restoration.  I will likely go back to non-GL
> > bumpers.
> >
> > John