here's a picture..
https://www.bus-ok.de/T3-Multivan-LLE-Halterung-fuer-Beplankung-kurz-Originalteil-Verglnr-255853993

On Wed, Nov 20, 2019 at 5:07 PM John H. Lauterbach <john@jhl.mgacoxmail.com>
wrote:

> Perhaps I did not word my question correctly.  For example, cladding on
> sliding
> door is hanging on by the top edge.  How do I get it off?  Knock it up
> with a
> rubber mallet?
>
> John
>
>
> On Wed, 2019-11-20 at 14:33 -0800, John Goubeaux wrote:
> > I believe it is a 10mm nut on the bolts that hold the cladding to the
> > clips.
> >
> > I used a small socket with an extender to remove/replace my cladding.
> > You will then be faced with removing the plastic vertical clips/holders
> > that are riveted to the body.
> >
> > -john
> >
> > On 11/20/19 12:38 PM, John H. Lauterbach wrote:
> > > My '91 GL only has part of the orignal GL panels still attached, and
> some of
> > > these are loose.  How do I remove them.  I doubt that I will replace
> them after
> > > I send van to body shop for restoration.  I will likely go back to
> non-GL
> > > bumpers.
> > >
> > > John
>