So I did not know what any of this was until I googled it.
I also found the pic from go westy. Im guessing there is a wire mesh under
the foam that you can tread the zip ties thru and place the tubing.
https://www.gowesty.com/images/ec/products/full/full_48573e763a28fe12169e396698ff25e5.jpg

hth,
T.

On Thu, Dec 12, 2019 at 8:45 AM Dan Lamb <vanagongramps@gmail.com> wrote:

> Hi John
>
> I just flipped the lid over, laid out the blazecut and drilled holes on
> each side and used zip ties to secure it. I caulked the holes after just
> because. Has worked well for several years. HTH
>
> Dan
> Country Homes Camper, the Huckleberry Sky
>
> > On Dec 11, 2019, at 10:53 PM, John H. Lauterbach <
> john@jhl.mgacoxmail.com> wrote:
> >
> > The engine cover has foam on the bottom and is a plastic cover, not the
> metal
> > engine cover on older Vanagons.  Looks like I need to mount the BlazeCut
> tubing
> > on the underside of the floor, just around the opening for the engine
> cover.
> > Has anyone done this?  If so, what do you use to hold the BlazeCut
> tubing in
> > place.
> >
> > Thank you,
> >
> > John
>