Thank you, Dan.  I have the tube (and I got the longer one) tied down with heavy
zip ties attached either to the heavier wire or through holes I drilled in the
ribs.  Once I check the clearances I will go with the tube fasteners.  I was a
very messy job, and I will need a couple of more hand washes with Fast Orange to
be presentable.  I have a Subie engine and not the Vanagon engine.
John
On Thu, 2019-12-12 at 16:39 -0800, Dan Lamb wrote:
> Don’t think the mesh will hold it. Fasteners should go thru the lid. I used
> cable clamps/zip ties. Works well
> Sent from my iPhone
> > On Dec 12, 2019, at 8:20 AM, T Collins <tonycollin@gmail.com> wrote:
> > So I did not know what any of this was until I googled it.I also found the
> > pic from go westy. Im guessing there is a wire mesh underthe foam that you
> > can tread the zip ties thru and place the tubing.
> > https://www.gowesty.com/images/ec/products/full/full_48573e763a28fe12169e396698ff25e5.jpg
> >
> > hth,T.
> > > On Thu, Dec 12, 2019 at 8:45 AM Dan Lamb <vanagongramps@gmail.com> wrote:
> > > Hi John
> > > I just flipped the lid over, laid out the blazecut and drilled holes
> > > oneach side and used zip ties to secure it. I caulked the holes after
> > > justbecause. Has worked well for several years. HTH
> > > DanCountry Homes Camper, the Huckleberry Sky
> > > > On Dec 11, 2019, at 10:53 PM, John H. Lauterbach <
> > > john@jhl.mgacoxmail.com> wrote:
> > > > The engine cover has foam on the bottom and is a plastic cover, not the
> > > metal
> > > > engine cover on older Vanagons.  Looks like I need to mount the BlazeCut
> > > tubing
> > > > on the underside of the floor, just around the opening for the engine
> > > cover.
> > > > Has anyone done this?  If so, what do you use to hold the BlazeCut
> > > tubing in
> > > > place.
> > > > Thank you,
> > > > John