Thanks Dennis. Helpful info. IIRC, the GoWesty upper control arm
bushings may require similar adjustments. The bushings supplied by T3
may not?

I may just go with Whiteline bushings from T3

Neil.

On 1/19/20, Dennis Haynes <d23haynes57@hotmail.com> wrote:

> I installed a set of these just before the holidays. Had to change the
> eccentric washers to set the pre-load. The inner sleeves are a slightly
> different length so thinner eccentrics were needed.
>
> Dennis
>
>
> -----Original Message-----
> From: Vanagon Mailing List <vanagon@gerry.vanagon.com> On Behalf Of Neil N
> Sent: Saturday, January 18, 2020 3:16 PM
> To: vanagon@GERRY.VANAGON.COM
> Subject: Nolathane upper control arm bushings?

> Anyone installed these Australian Nolathane REVO420086 Upper Control Arm
> Bushings

-- 
Neil n

VE7TBN

1988 Westy 50º ABA swap: https://tinyurl.com/yap5hpwt

1981 Westy 15º ABA swap: https://tinyurl.com/y9n4xob8

VAG Gas Engine Swap Group <http://tinyurl.com/khalbay>