

| Subject: | Re: Replacing 1.9 Thermostat Short Hose |
| From: | Steven Shelton |
| Date: | Tue, 18 Feb 2020 13:54:13 -0500 |
Thanks for the link. I didn't find that one. I replaced the thermostat and hose eight years ago, but I don't remember if I pulled the pump or not. I know I didn't have any problems with bolts; maybe being in the south it doesn't corrode as much. I can hope. What I do remember is being shocked about how much pitting there was in the housing. I can see it perforating at some point. I've had my eyes open for a good used one since then, but haven't seen one anywhere. I wonder if some kind of epoxy would prevent that. It might also peel off and clog the cooling system. On Tue, Feb 18, 2020 at 1:26 PM Richard Koerner <rjkinpb@sbcglobal.net> wrote: > Here is some info on replacing the short hose: > https://www.thesamba.com/vw/forum/viewtopic.php?t=596873 > Just for fun....I did a quick check on 1.9 Thermostat Housings at GoWesty, > VanCafe, Bus Depot, and Vanagain. Only Ken at Vanagain mentioned that even > though NLA, he "usually" has a used one that he has cleaned up. > > Good luck. > > Rich > > > On Tuesday, February 18, 2020, 9:51:11 AM PST, Richard Koerner < > rjkinpb@sbcglobal.net> wrote: > > Another warning: be super careful when removing a 1.9 Thermostat > Housing. Maybe 12 years ago or more, I took my vehicle to an experienced > VW shop for water pump replacement. In doing so, the mechanic > cracked/broke the housing. Even back then....they were no longer > available! I was able to find a used housing at a local VW scrap yard and > the story ended happily. > > Rich > San Diego > > On Tuesday, February 18, 2020, 9:31:44 AM PST, Thomas Casal < > thomas.casal@gmail.com> wrote: > > I’m no expert but I don’t see why you couldn’t. beware of those bolts they > are usually rusty and rusted on. > > On Tue, Feb 18, 2020 at 12:14 PM Steven Shelton <shelton4@gmail.com> > wrote: > > > I have a leak at the short hose between the thermostat housing and > engine. > > Do I have to remove the water pump as well as the thermostat housing or > can > > I take off the two bolts and the hoses then pull the housing off? > > >
Have something to add on this topic today? Revive this thread in the forum »