Hi Jim,

Sounds like you were one step ahead of us.  Let us know how it goes with time. 

I hope to eventually join you in using at least a little of that space. Or possibly both sides. 

Eric 

> On Feb 23, 2020, at 3:57 PM, Jim O'Connor <jimmy.oco@gmail.com> wrote:
> 
> Thanks Eric.
> I have the Bostig conversion, that uses a Ford 2L zetec engine.
> The air intake is on the drivers side so the space behind passenger Tail light is available.
> I only did this recently so i don't know yet if there will be issues, but I can fit quite a bit of stuff back there.
> Mostly all my tools.
> regards
> JIM
> 
> 
> On Sun, Feb 23, 2020 at 12:42 PM Eric Caron <ericcaron96@comcast.net <mailto:ericcaron96@comcast.net>> wrote:
> Hi Jim,
> 
>       Sure enough, you beat us to the idea.  Your solution sounds like one Dennis and DeanB tossed out. 
> 
> Sounds like you are finding that space helpful.
> 
> What is the moisture and water situation like?  How is the air intake effected?  What engine are you running?
> 
> Thanks for sharing your experience!
> 
> Eric Caron 
> 
> 
> 
>> On Feb 23, 2020, at 12:38 PM, Jim O'Connor <jimmy.oco@gmail.com <mailto:jimmy.oco@gmail.com>> wrote:
>> 
>>  I made a cover to make use of a ton of space behind the passenger taillight. I can pretty much get all my tools back there. Decked it out with a bostig sticker 
>> its just a piece of scrap metal I had. I cut it to this shape, stuck a bostig sticker on it, and voila. There are a couple of locator pins at the very top lip, and a locator pin at the bottom. These pins are just part of the van that I found helpful to locate/position the cover. Currently it is secured at the top with velcro, but I may change that.  
>>  
>> 
>> On Sun, Feb 23, 2020 at 10:18 AM Eric Caron <ericcaron96@comcast.net <mailto:ericcaron96@comcast.net>> wrote:
>> Hi Jim,
>> 
>> I tried to go to the link but it says page not found.  Any chance you can give us a verbal description or another link to your info?
>> 
>> Very interested.
>> 
>> Eric 
>> 
>> 
>> 
>> 
>>> On Feb 23, 2020, at 9:56 AM, Jim O'Connor <jimmy.oco@gmail.com <mailto:jimmy.oco@gmail.com>> wrote:
>>> 
>>> https://www.facebook.com/photo?fbid=10163116662230220&set=gm.1534294226732947 <https://www.facebook.com/photo?fbid=10163116662230220&set=gm.1534294226732947>
>>> 
>>> don't know how to post. This is what i did.
>>> 
>>> Jim
>> 
>> <83878674_10163116662240220_6926625772668977152_o.jpg>
>