

| Subject: | Re: Leaky windshield washer fluid reservoir |
| From: | Eric Caron |
| Date: | Sun, 25 Apr 2021 19:53:11 -0400 |
Phew! That is how I remember it but thought it was too easy. Eric Caron Jeff check it out and report back. > On Apr 25, 2021, at 7:33 PM, Alistair Bell <albell@SHAW.CA> wrote: > > Drops right down after you remove the three m6 ( 10 mm head size) bolts on the tabs on the tank. > > There is enough wire to drop the tank so you can disconnect the pump. > > Filler pipe stays in van, it just slips out of the grommeted hole on top of tank. > > Pump to tank grommet may be the leak. But you seem to imply the leak is big. > > Wasnt there someone making a skid plate to protect the tank, and hold the tank up if your tabs are broken? > > Alistair > >> On Apr 25, 2021, at 12:16 PM, Jeff Palmer <w.jeff.palmer@icloud.com> wrote: >> >> Hi everyone. 85 Westfalia GL here. >> >> My front windshield washer reservoir leaks when I fill it. I don’t believe it’s holding any fluid so I suspect the entire tank is kaput not just grommets or hose. >> >> How hard are these to change? The van isn’t nearby and I can’t tell from the schematic. Last time I stuck my head under there it appeared more complex than I was expecting. >> >> GoWesty lists two grommets (for the pump and reservoir) and the tank. Are these all necessary would you say? >> >> Thanks >> Jeff
Have something to add on this topic today? Revive this thread in the forum »