That's the simplest, most elegant solution Bell Enterprises has ever come
up with.

It's not CNC machined out of beryllium. : )

Jim

On Mon, Aug 1, 2022 at 10:21 AM Alistair Bell <albell@shaw.ca> wrote:

> An example of….
>
> Better to light a candle than ti curse the darkness
>
> :-)
>
> Ab
>
> > On Aug 1, 2022, at 8:19 AM, Eric Caron <ericcaron96@comcast.net> wrote:
> >
> > Well now isn’t that a nice straight forward solution!
> >
> >    Eric Caron
> >
> >
> >> On Aug 1, 2022, at 11:10 AM, Alistair Bell <albell@SHAW.CA> wrote:
> >>
> >> Or just pull that fuse in the little box at the drivers side b pillar.
> Or a switch there
> >>
> >> Alistair
> >>
> >>>> On Aug 1, 2022, at 8:09 AM, Jim Felder <jim.felder@gmail.com> wrote:
> >>>
> >>> The surprise for me is that there is not a cut-out for the fan
> circuit at
> >>> any place where there could be one.
> >>>
> >>> Maybe a high-temp switch near the burner and a relay for the electric
> modes?
> >>>
> >>> Jim
> >>>
> >>>> On Mon, Aug 1, 2022 at 10:05 AM Alistair Bell <albell@shaw.ca> wrote:
> >>>>
> >>>> What I did some years ago, was to take out the stick thermo switch on
> the
> >>>> back fins and replace with thermo probe for a programable tstat. Was
> during
> >>>> my ongoing effort to make the propane fridge work a wee bit better.
> >>>>
> >>>> I thought I’d play with lower temp setting for the fan to come on.
> Last
> >>>> year I replaceded the original , kinda clunky , programable unit for a
> >>>> slimmer inkbird brand one.
> >>>>
> >>>> I wasn’t convinced that adjusting the fan set point really did much.
> But
> >>>> the obvious benefit was the fan would stay off if the control unit
> was off.
> >>>> No runaway fan on a hot day thing, that this thread is about.
> >>>>
> >>>> Funny how it’s still a surprise for some that the stock fan works that
> >>>> way  :-)
> >>>>
> >>>> Alistair
> >>>>
> >>>>> On Jul 31, 2022, at 12:46 PM, Jeff Palmer <w.jeff.palmer@icloud.com>
> >>>> wrote:
> >>>>>
> >>>>
> >
>