Ok, thanks. BY CARRIER BEARINGS I mean the bearings for the stub/flange
that sticks out of the transaxle that the CV's mount to. I can get OBD 2
readouts on my phone. Just haven't done that yet. Tonight perhaps. At 70
mph the tach reads 4000 rpm. 70 MPH IS THE MAX I will ever drive it. 60 to
65 in most places. I'm not in that big of a hurry to go anywhere at my age.
eVENTUALLY i will install a temp gauge for ATF temp monitoring. As always
if you own a Vanagon it's an ongoing project.

On Sun, Aug 21, 2022 at 5:24 PM Dennis Haynes <d23haynes57@hotmail.com>
wrote:

> By what are you referring to as the "carrier Bearings". What are you using
> for the vehicle speed sensor? If possible use the OBD 2 to see what the ECU
> is seeing as the vehicle speed. Since you are running automatic with
> original gearing you need to get the VSS to rear close to what the engine
> would expect at over 4,000 rpm. For that engines original application 70
> mph would be well under 3,000 rpm. For best results you probably need a
> 3.27 RP set and some serious ATF cooling and temperature monitoring.
>
> Dennis
>
>
> -----Original Message-----
> From: Vanagon Mailing List <vanagon@gerry.vanagon.com> On Behalf Of John
> Rodgers
> Sent: Sunday, August 21, 2022 4:33 PM
> To: vanagon@GERRY.VANAGON.COM
> Subject: A mystery
>
> I have a fairly new Subaru engine conversion in my van.  The engine itself
> is basically new by way of an overhaul. It has 800 miles on it now. The
> carrier bearings are a bit worn and they wobble sufficiently at 70 mph as
> to cause the VSS to get erroneous signals which in turn causes the engine
> to jerk like misfire or improper or inadequate fuel mixture. The carrier
> bearing problem will be fixed next week. IF I keep speed below 70 then no
> problem. However in ranges between 55 and 65 the engine will sometimes
> suddenly shut off as if Ihave turned off the ignition. If I keep my foot on
> the gas pedal then the van continues to slow down. If Ilet of the pedal a
> few seconds the engine picks up and continues on its merry way.
>
> Anyone have any idea what could cause this?
>