Thank you everyone. I will have a look tomorrow.

-Jamie
The Kooky Math Teacher

Sent from my iPhone

> On Dec 3, 2022, at 5:12 PM, Eric Caron <ericcaron96@comcast.net> wrote:
> 
> This list rocks,
> 
> Jamie, it sounds like a straightforward fixe.  Of course if rusty there is a little more work but you can do it!
> 
> 
> And now for safety I’m going to go check my peddles.
> 
> Eric Caron 
> 
> 
> 
>> On Dec 3, 2022, at 3:59 PM, Alistair Bell <albell@shaw.ca> wrote:
>> 
>> Stock is pop rivet.
>> 
>> Can replace with same or screws, or nuts and bolts. There is a good possibility there is rust on the floor where the rivets were seated.
>> 
>> Alistair 
>> 
>>>> On Dec 3, 2022, at 12:42 PM, Jamie Auch <jamie@kookymathteacher.com> wrote:
>>> 
>>> Dear Folks,
>>> I have a quick question that should
>>> not take time away from the list. I was driving along and I lost tension on accelerator pedal on my ‘89. Luckily it was not the cable but the pedal itself separated from the floor. How is the pedal attached? I saw two holes, but could not find the screws. Please advise. Thanks so much
>>> -Jamie Auch
>>> The Kooky Math Teacher
>>> Sent from my iPhone