Hi Eric,
It’s been a busy week at boarding school with being on duty this weekend. I will keep all updated.
Thanks for asking!

-Jamie
The Kooky Math Teacher

Sent from my iPhone

> On Dec 5, 2022, at 7:37 PM, Eric Caron <ericcaron96@comcast.net> wrote:
> 
> Hi Jamie,
> 
> Any updates on your excelerator pedal? 
> 
> Hope you are back in business.
> 
> Eric 
> 
> 
>> On Dec 3, 2022, at 8:08 PM, Jamie Auch <jamie@KOOKYMATHTEACHER.COM> wrote:
>> 
>> Thank you everyone. I will have a look tomorrow.
>> 
>> -Jamie
>> The Kooky Math Teacher
>> 
>> Sent from my iPhone
>> 
>>>> On Dec 3, 2022, at 5:12 PM, Eric Caron <ericcaron96@comcast.net> wrote:
>>> 
>>> This list rocks,
>>> 
>>> Jamie, it sounds like a straightforward fixe.  Of course if rusty there is a little more work but you can do it!
>>> 
>>> 
>>> And now for safety I’m going to go check my peddles.
>>> 
>>> Eric Caron 
>>> 
>>> 
>>> 
>>>> On Dec 3, 2022, at 3:59 PM, Alistair Bell <albell@shaw.ca> wrote:
>>>> 
>>>> Stock is pop rivet.
>>>> 
>>>> Can replace with same or screws, or nuts and bolts. There is a good possibility there is rust on the floor where the rivets were seated.
>>>> 
>>>> Alistair 
>>>> 
>>>>>> On Dec 3, 2022, at 12:42 PM, Jamie Auch <jamie@kookymathteacher.com> wrote:
>>>>> 
>>>>> Dear Folks,
>>>>> I have a quick question that should
>>>>> not take time away from the list. I was driving along and I lost tension on accelerator pedal on my ‘89. Luckily it was not the cable but the pedal itself separated from the floor. How is the pedal attached? I saw two holes, but could not find the screws. Please advise. Thanks so much
>>>>> -Jamie Auch
>>>>> The Kooky Math Teacher
>>>>> Sent from my iPhone
>