Ok, thanks. I need to replace the bearing and race on each side that t5he
stub axle rides in. Is that relatively easy to do? Anything specific to
watch out for? I take it I don't have to enter the housing where the
differential is?

On Sun, Jan 8, 2023 at 8:38 PM Dennis Haynes <d23haynes57@hotmail.com>
wrote:

> After removing the CV joint and cleaning out the grease, there is a screw
> in the center with a 6mm Allen socket head. Remove the screw and then the
> stub axle will slid right out. Note the Stub axle and screw is different
> right/left side. An impact wrench wil make this task easier but be careful
> not to strip out the Allen Socket Hex.
>
> Dennis
>
>
> -----Original Message-----
> From: Vanagon Mailing List <vanagon@gerry.vanagon.com> On Behalf Of John
> Rodgers
> Sent: Sunday, January 8, 2023 8:29 PM
> To: vanagon@GERRY.VANAGON.COM
> Subject: Vanagon automatic trans stub axle with flange
>
> Not sure I have the name right. Is there a photo or video anywhere that
> shows this being removed. I've searched high and low.
>