No way I’m removing that.  If accessible I don’t mind checking bolt tightness but I’m not sure until I go check it out. 

Eric Caron 

> On Apr 3, 2023, at 5:30 PM, Dan N <dn92610@gmail.com> wrote:
> 
> a bit of warning.... if you remove the breather, be *super, super*
> careful...
> 
> do not drop a nut or a washer into the engine... it will be a nightmare to
> get it out...  :-)
> 
> On Mon, Apr 3, 2023 at 2:25 PM OlRivrRat <OlRivrRat@comcast.net> wrote:
> 
>>> On 3 Apr , 2023, at 3:00 PM, Dennis Haynes <d23haynes57@hotmail.com>
>> wrote:
>>> 
>>> For the oil breather tower, ... I usually use a gasket for the Beetle
>> engine oil tower between this bracket and the case.
>>> 
>>> Dennis
>> 
>> 
>>        Initially, it might be a good idea just to be sure Its 4 securing
>> nuts are Tight ~
>> 
>>                                                        ORR ~ DeanB