Dan

        It is most likely the Latch itself that needs Repositioning as that controls

how Closed the Rear of the Slider ends up,,, The LBracket @ the bottom ends

up in front when the slider is closed so would have little to no effect on rear

of slider when closed ~

                                                        ORR ~ DeanB

> On 1 May , 2023, at 12:58 PM, Dan N <dn92610@GMAIL.COM> wrote:
> 
> Hi all,
> 
> The sliding door on my van closes well, slides well. The rollers were
> replaced about a year ago.
> 
> But... the left edge of the door (looking from outside) is not flushed with
> the body panel. I tried to adjust the L bracket that holds the bottom
> roller. I loosen the bolts and moved the door a bit in and out... No good
> result, no change...
> 
> So.. is there anything else I should do?
> 
> thank you...