thanks Dean...

I will try that and report back... btw.. the front latch or the rear latch?

On Mon, May 1, 2023 at 3:52 PM OlRivrRat <OlRivrRat@comcast.net> wrote:

>                 Dan
>
>         It is most likely the Latch itself that needs Repositioning as
> that controls
>
> how Closed the Rear of the Slider ends up,,, The LBracket @ the bottom ends
>
> up in front when the slider is closed so would have little to no effect on
> rear
>
> of slider when closed ~
>
>                                                         ORR ~ DeanB
>
>
>
> > On 1 May , 2023, at 12:58 PM, Dan N <dn92610@GMAIL.COM> wrote:
> >
> > Hi all,
> >
> > The sliding door on my van closes well, slides well. The rollers were
> > replaced about a year ago.
> >
> > But... the left edge of the door (looking from outside) is not flushed
> with
> > the body panel. I tried to adjust the L bracket that holds the bottom
> > roller. I loosen the bolts and moved the door a bit in and out... No good
> > result, no change...
> >
> > So.. is there anything else I should do?
> >
> > thank you...
>
>