Thank you Dean...

hurray... success ! ! but... here's the thing... If I pull the door to
close and let go of the handle the door will close but the rear won't align
with the body panel.
If I keep my hand on the handle and close the door and push in a little
bit, the rear will align with the body panel.
I'd think the front latch needs a bit of help to close correctly.

On Tue, May 2, 2023 at 8:21 AM OlRivrRat <OlRivrRat@comcast.net> wrote:

>         There is only 1 Latch & it is on the Rear,,, There is a Retainer on
>
> the Front which appears to be just a safety catch to help prevent the
>
> Front of the slider from opening in an accident,,, The Front adjustment
>
> is done via the LBracket that You already have been adjusting ~~
>
>
>
> > On 1 May , 2023, at 5:00 PM, Dan N <dn92610@GMAIL.COM> wrote:
> >
> > thanks Dean...
> >
> > I will try that and report back... btw.. the front latch or the rear
> latch?
> >
> > On Mon, May 1, 2023 at 3:52 PM OlRivrRat <OlRivrRat@comcast.net> wrote:
> >
> >>                Dan
> >>
> >>        It is most likely the Latch itself that needs Repositioning as
> >> that controls
> >>
> >> how Closed the Rear of the Slider ends up,,, The LBracket @ the bottom
> ends
> >>
> >> up in front when the slider is closed so would have little to no effect
> on
> >> rear
> >>
> >> of slider when closed ~
> >>
> >>                                                        ORR ~ DeanB
> >>
> >>
> >>
> >>> On 1 May , 2023, at 12:58 PM, Dan N <dn92610@GMAIL.COM> wrote:
> >>>
> >>> Hi all,
> >>>
> >>> The sliding door on my van closes well, slides well. The rollers were
> >>> replaced about a year ago.
> >>>
> >>> But... the left edge of the door (looking from outside) is not flushed
> >> with
> >>> the body panel. I tried to adjust the L bracket that holds the bottom
> >>> roller. I loosen the bolts and moved the door a bit in and out... No
> good
> >>> result, no change...
> >>>
> >>> So.. is there anything else I should do?
> >>>
> >>> thank you...
> >>
> >>
>
>