

| Subject: | Re: Adjust Battery LED Pot |
| Date: | Sun, 27 Nov 1994 13:23:21 -0500 |
On Sat, 26 Nov 94 21:28:44 CST, DerekDrew@aol.com wrote:
> I adjusted the pot behind my LED panel with a simultaneous volt meter
> attached to the battery. I turned lights on and off until the volt meter read
> 12.5 volts and then I adjusted the pot so the green light just went on.
> (since 12.6 volts is a full battery). At 12.4 volts the LED reads yellow.
>
> You all know that 11.9 volts is a dead battery; 12.25 is half charged, and
> 12.6 is fully charged, right?
>
No, that's not true. A battery in good shape, fully charged would
read about 13.5 volts, not 12.6. Any battery that only reads 12.6 after
a good charging-up is ready for retirement. And anything reading only
12 or less is junk. In fact, I wouldn't dream of keeping any battery
this time of year that read anything less than 13v after a charge.
Harmon Seaver
hseaver@nyx.cs.du.edu
seaverh@vaxa.cis.uwosh.edu
harmon@buffet.engr.wisc.edu
<><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><>
<> "The Way of the Samurai is death." - Jocho Yamamoto 1710 Hagakure <>
<> "Let no man's life stand in the way -- especially your own." <>
<> Miyamoto Musashi 1584-1645 <>
<> "The fundamental delusion of humanity is to suppose that I am here <>
<> and you are out there." Yasutani Roshi <>
<><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><>Have something to add on this topic today? Revive this thread in the forum »