My gas gauge is out on my 78' bus. 2 liter engine, 7 passenger. I know
the gauge in the dash is fine, and I was told it was probably the float
in the tank. I was also told the only way to get to the float was to
remove the engine, transmission, gas tank, etc.. I was wondering if it
was possible to nibble out a hole from the rear floor/riser behind the
rear seat to get access to the float, replace/fix it, then seal the hole
back up with tiger hair. Any thoughts? The main info I'd need is where
to cut the hole, plus any other ideas...

Thanks.

Marc Bartholomew
mb7y@andrew.cmu.edu
retread@cmu.edu