> My 64 has a very worn bushing on the center kingpin. Not to be confused
> with the kingpins that the wheels are attached with. This is the one that
> goes through the center of the top torsion bar. I would like to remove it
> and replace the bushing without removing the entire front end. Is there 
> an easy way to remove the ball joints from the tie rods? Any advice 
> concerning these procedures would be greatly appreciated.

I believe the October '94 issue of Hot VWs described this problem along
with a step by step process to fix it.  If you don't subscribe, check out
your local library's periodicals archive.

-- 
   Jerry Huff           Data General       _____     Brick
   Unix Development     RTP, NC 27709     | |_|_\      on       \/
   huff@dg-rtp.dg.com   (919)248-6277     `0---0'    Wheels    \/\/