>From schwarze@superc.nosc.mil  Sat May  6 20:49:02 1995
>From: David Schwarze <schwarze@superc.nosc.mil>
>Subject: Re: conduit for your bus?
>Date: Sat, 6 May 1995 18:49:01 -0700 (PDT)

Christopher Bridge writes:
> I was thinking about running a piece of flexible conduit under my bus to 
> allow for the many wires I'll be running for the gauges.  Has anyone done 
> this, or better yet how and where do you run the wires for the gauges?  I 
> saw some stuff called "ENC", which stands for electrically non conductive 
> conduit.  It was $2.50 for 10 feet.  There are some connectors and such made 
> for this stuff as well.  All in all, it would only cost around 6 bucks to 
> run the length of the bus.  What do you think?

I think I did this and it was a frigging nightmare.  I couldn't find a ten
foot piece of the stuff, so I used three 4-foot pieces and some twist ties 
to hold them together.  I ran the plastic conduit and 4 wires through the
holes in the frame rails and then through a hole in my engine tin.  One of
the dirtiest jobs I have ever done, cause dirt kept falling in my face as I
lay on my back under the bus.  It probably would be a cakewalk if you could
put your bus up on a lift, though.  Goggles are a necessity for this job.

-David

============================================================================
David Schwarze                     '73 VW Safare Custom Camper  (Da Boat)
SAIC Comsystems, San Diego Calif.  '73 Capri GT 2800            (Da Beast)
e-mail:  schwarze@nosc.mil         '87 Mustang Lx 5.0           (Da Sleeper)
http://papaya.nosc.mil/~schwarze   '93 Weber WG-50              (Da Piano)
============================================================================