>Greetings all
>
>I have a second hand 2 litre short block which I intend 
>rebuilding and fitting into an 1800 Kombi camper.  
>
>Upon dismantling the case I discovered writing (VW logo and
>some numbers) on one of the main bearing journals (no. 2) which
>suggests to me that the case has not previously been align bored.  
>Does this logic hold true for those in the know?  
>
>Thanks in advance.
>
>Aaron Sedgmen
>asedgmen@agso.gov.au

I don't think your logic is all that good.  The case could have been line 
bored and then oversize bearings installed.  I don't think that the VW logo 
means bonestock parts.  The best way to tell is to measure the bore.  The 
case should measure 70 mm (2.7559") if it is standard.  You should be able 
to measure this roughly with a ruler which has at least .5 mm increments.  
Line bore oversizes are .020, .040, .060, .080 inches.

If it is in good shape, and standard bore, I'd think you have a jewel there.

Chris.(Don't know much about T4's)