I thought about doing the hole bit to drain it, but was trying to hold 
out for some type of adter market gasket.  I didn't want to use any 
sealant as then it would be a pain to try and change the bulb.  I was 
thinking more in terms of possibly cutting pieces out of an ordinary 
rubber gasket to make some type of seal.

Lewis Horn
z006539b@bcfreenet.seflin.lib.fl.us

On Wed, 10 May 1995, Joel Walker wrote:

> On Wed, 10 May 95 Dean Aukes replied to what Lewis Horn said:
> >>Has anyone had a problem with the front turn signal(amber) housings
> >>filling with water after a heavy rain?  Ours has filled on several
> >>occasions causing corrosion of the wires and damage to the bulb socket.
> >>Does anyone know if a good after market gasket is made to fill in the
> >>small space between the body and the lamp housing?  Thanks!
> >
> >Lewis,
> >Please let me know if someone posts a solution to this directly to you.  I
> >have the same problem on my '73.
> 
> one quick and very dirty solution is to remove the turn signal lens and
> drill a small 1/8" hole in the bottom edge of the lens housing ... to allow
> the water to drain out.
> 
> note that this does NOT "solve" the problem, but only allows the water to
> exit ... so it cuts down on the corrosion.
> 
> one solution would be to hit the junkyards and see what you could find, or
> buy some tubes of rubber gasket stuff, make a big bead of it around the
> back of the housing, let it set up and dry, then put the housing back on.
> 
> 
> joel
>