Ron Van Ness writes:
> 
> quite expensive.  I've broken the heads on craftsman socket wrenches by
> overtorquing them and I bent up a 3/4" slide bar taking off a rear axle nut,
> it looked like a big "Z" when I was through.  I have yet to break any type
> of box type wrench, though.  Some day, after winning lotto, I'll proudly
> step up to the curb and hail the Snap-on truck.  But until then...

I think Craftsman tools are still fairly good.  The only one I've
ever broken is the 3/8" u-joint ratchet extension, and I expected it to
break.  I also like Craftsman sockets because they are thin-walled and
allow you to get a socket over bolts that are real close to something.
I've never broken one yet, but for the really stressful jobs I use
impact sockets.  Good luck breaking one of those!  Until someone comes
out with stronger, cheaper tools, I'll be buying Craftsman.

-David

============================================================================
David Schwarze                   '73 VW Safare Custom Camper       (Da Boat)
San Diego, California, USA       '73 Capri GT 2800                (Da Beast)
e-mail: des@teleport.com         '87 Mustang Lx 5.0          (13.986@100.81)
http://www.teleport.com/~des     '93 Weber WG-50                  (Da Piano)
============================================================================