

| Subject: | Re: '77 Westy: Interference between Bed and Table |
| From: | Kirk D. Hilliard |
| Date: | Mon, 20 May 1996 18:31:14 -0400 |
[ Concerning modifying rear seat bottom so that it can be converted into a bed without removing the table support. ] > Whew, I thought about this one a lot on my 6 month trip to Mexico. > Never did anything about it though. > > Observations: > - I think you're just looking for the convenience of leaving the > support in place. The table gets in the way of the bed when it's > being unfolded, right? No. When I deploy the bed I usually lift the seat bottom to a height that would interfere with the table (were it there) but the bed can be deployed (up to the point where it hits the vertical section of the pipe) with the table in place. The easiest way to do this is to lift the seat bottom up only about 20 degrees before pulling it forward. If you lift it up about 30 degrees it will click into place, making things more difficult. (If that happens, you can unlatch it pulling the seat forward slightly and then lifting the seat bottom up a bit.) It is only a little more difficult to convert the bed back into a seat with the table in place. Just start the process by lifting the rear of the middle section of the bed. > - I don't think the bracket is important for bed support, though. > Otherwise the back of the upholstery would be torn up on my bed... Right. The bed is supported by its own brackets and rests one to two inches above the table support bracket. > Where do you normally store the support bar and table ?? Contrary to instructions in the owner's manual, I keep the bar and table in place when I drive, but I have not come up with a good place to store them when I want to convert the seat into a bed, and this is what prompted me to write the first note. I usually wind up putting the table on top of the main cabinet and the bar on the floor (often after clearing the cabinet top of the luggage that I just moved there from the rear of the bus). I will probably go ahead and make the modification, but I will not be able to do it for a few weeks. I'll let you all know how it turns out. Kirk Hilliard '77 Westy
Have something to add on this topic today? Revive this thread in the forum »