

| Subject: | Re: A/C compressor not turning |
| Date: | Mon, 13 May 1996 18:06:59 -0400 |
>This weekend I tried the A/C and I noticed the engine didn't change >speed when the compressor supposedly kicks in. Sure enough, when the >A/C is switched on, the compressor clutch didn't engage. >Outside temperature was 70F so the temp sensors should have allowed the >compressor to engage. >Before I have it looked at by a professional, does anyone have >any suggestions or recommendations? I welcome all thoughts and opinons >since my A/C knowldge is very limited. Is this the first time you've tried to run the A/C in some time? I'd be willing to bet that over time or through some unknown incident the freon has evaporated from the system. There is a safety switch in the A/C system that does not allow the compressor to engage if the pressure in the system is too low, thus preventing damage to the system. One quick check is to find the fill valve (it looks like a valve stem on your tire) and press on the valve to release a little pressure. If nothing is released when you do this, then the freon has escaped from the system. At this point you have to find out why, rather than just recharging the system. This usual requires a mechanic, unfortunately. With this in mind, it might be a good time to upgrade the entire A/C system to the new ozone-friendly refrigerant. Ryan
Have something to add on this topic today? Revive this thread in the forum »