At 5:14 PM 6/20/96, Linda J. Bartnik wrote:
>
>Now, as I said before, I will be installing the gauge in the dummy plate
>next to
>the speedometer in my '78 bus.  Someone said that I could get a hole drill bit
>to drill the hole for the gauge.  I've never heard of this, but I'm new to
>drilling :) , so would sears have this?  Any tricks I need to know?

Make sure to get the hole saw that is made for cutting metal.  The ones for
wood look tough but aren't (Ask me how I know).  The metal-cutting one will
set you back about $10.  If you don't want to spend that much, you can do
it like I did.  Mark the circle in the plate, and drill many, many small
holes just *inside* the line.  Drill the holes as close together as you can
without touching.  Then break out the inside piece, and use a curved metal
file to smooth the rough edge.  The lip of the gauge will cover the edge of
the cut, so it doesn't have to be exactly perfect.  Good luck...

-David

============================================================================
David Schwarze                   '73 VW Safare Custom Camper       (Da Boat)
Dallas, Texas, USA               '73 Capri GT 2800                (Da Beast)
e-mail: ddes@anet-dfw.com        '87 Mustang Lx 5.0          (13.986@100.81)
http://www.anet-dfw.com/~ddes    '93 Weber WG-50                  (Da Piano)
============================================================================