Joel,
Thanks for the info on the shifter plate.  As soon as the rain stops,
I'll give it a go.

As for the mudflap - It appears that even if I removed the 'Westie'
stuff and the "wall",
I still wouldn't be able to get inside.  It looks like my best bet is to
borrow my 6 year old
nephews arm to reach into the piller to hold the fastener down while I
tighten.  If this works
I'll be looking for a passenger side flap.  Any for sale out there?

Does anybody have a list of part numbers for ALL of the coolant, fuel
and vacuum hoses.  This will
be my next adventure.  Any advice would be greatly appreciated.

Until last week-end the van had lost hardly a drop of coolant.  But
after a long, hard drive through
the local canyons and being parked on a slight incline over night, she
spilled
about 1/4 cup of coolant to the ground a little left of center engine. 
I had added a small amount to
the check tank before the venture - about the same amount I lost.
Hmmmm... could the tanks markings be 
incorrect?

Thanks,

Dan
'87 Westie 

Joel Walker wrote:
> 
> On Sat, 11 Jan 1997 13:26:30 -0600 you said:
> 
> >2) Has anyone replaced the drivers side mud flap?  And if so what
> >fastener did you use?  How did you reach into the body panel to
> >   hold it in place?
> 
> can't help. i was gonna add those flaps on both sides and could never figure
> out how to secure them to the body. :( wound up selling them. there has to
> be some way ... i'd suggest taking off the "wall" interior panel and seeing
> what you can see from in there.
> 
> joel